Glasdon Single Orbis Sign Kit Installation Instructions

SINGLE ORBIS SIGN KIT

IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE

EQUIPMENT REQUIRED:

- 13mm Spanner

KIT CONTENTS:

ITEM 1 - Sign Carrier

ITEM 2 - M8 x 130mm Hex Bolt

ITEM 3 - M8 Washer

ITEM 4 - M8 Nyloc Nut

INSTALLATION INSTRUCTIONS

x 2

x 1

x 4

Orbis Post (supplied separately)

DIAGRAM NOT TO SCALE

Table of Contents

Do you have a question about the Single Orbis Sign Kit and is the answer not in the manual?

Page 1 SINGLE ORBIS SIGN KIT INSTALLATION INSTRUCTIONS IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE EQUIPMENT REQUIRED: - 13mm Spanner KIT CONTENTS: ITEM 1 - Sign Carrier ITEM 2 - M8 x 130mm Hex Bolt ITEM 3 - M8 Washer...
Page 2 NEW SIGN KIT INSTALLATION Insert the M8 Hex Bolts through the Orbis Insert the Orbis with the bolts through the holes of the Orbis Post(supplied separately). fixing holes. Locate the Sign Carrier’s fixing holes on to the Secure in position with M8 Washers and Nuts exposed bolts protruding through the rear of using 13mm Spanners.
Page 3 DOUBLE ORBIS SIGN KIT INSTALLATION INSTRUCTIONS IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE EQUIPMENT REQUIRED: - 13mm Spanner KIT CONTENTS: ITEM 1 - Sign Carrier ITEM 2 - 2 Point Bracket ITEM 3 - M8 x 200mm Hex Bolt ITEM 4 - M8 Washer ITEM 5 - M8 Nyloc Nut Orbis Post (supplied separately)
Page 4 THAT A COPY IS GIVEN TO STAFF INVOLVED WITH THE INSTALLATION AND MAINTENANCE OF THIS PRODUCT. SAFETY NOTE: PLEASE REFER TO ‘THE MANUAL HANDLING OPERATIONS REGULATIONS 1992’ DURING HANDLING. AND ORBIS SIGN KIT ARE TRADEMARKS OR REGISTERED TRADEMARKS OF GLASDON GROUP OR ITS SUBSIDIARIES IN THE U.K. AND OTHER COUNTRIES A planned maintenance schedule or regular inspection is recommended, replacing components as necessary.