Table of Contents
Advertisement
MIDI Merge (Cont'd)
In Orchestron and Panoptigon modes, the Chord Controller will keep
track of MIDI NOTE ON and NOTE OFF data sent from a MIDI device
connected to the MIDI IN jack and MIDI data generated internally by the
Chord Controller. This is so notes played from a keyboard controller will
not be cancelled by the Chord Controller, and notes played by the Chord
Controller will not be cancelled by the keyboard controller. Notes will turn
off only when both controllers release the notes.
Hook Up (Power Supply Connections)
The Chord Controller is powered from 24VDC. The Quilter Labs PS-24
power supply should be used to provide the proper source of this DC
power. If you already have a Panoptigon, you can run both the Chord
Controller and the Panoptigon from the Panoptigon's PS-24 supply. To
do this, plug the DC plug from the PS-24 into the Chord Controller's
rear power input jack marked IN, then using the supplied power cable
jumper, plug the jumper from the power jack marked OUT to the power
jack of the Panoptigon (see picture below). If using the Chord Controller
without a Panoptigon, you can purchase a PS-24 from Quilter Labs, and
plug the supply's output plug into the jack marked IN, leaving the OUT
jack open.
After connecting the power supply to the Chord Controller, plug the AC
cord from the power supply into an AC outlet. Confirm that the green
light on the power supply is lit, and the red light (near the top right) of
the Chord Controller is lit. If using the Panoptigon Disc Player as a sound
source, it can now be turned on.
Connect to:
7
Advertisement
Table of Contents
