Connecting The Supply Hose - LG SIGNATURE WTS02TLWHN Owner's Manual

Connecting the Supply Hose

• Water supply pressure must be between 0.1
MPa and 0.8 MPa (1.0‒8.0 kgf/cm
• Do not overtighten the water supply hose.
• If the water supply pressure is more than
0.8 MPa, a decompression device should be
installed.
• Periodically check the condition of the hose
and replace the hose if necessary.
• Contact the service centre if there is no rubber
seal.
Checking the Rubber Seal on the
Supply Hose
Two rubber seals are supplied with the water
supply hoses. They are used for preventing
water leaks. Make sure the connection to taps is
sufficiently tight.
Hose connector
Rubber seal
Hose connector
Rubber seal
16
Connecting Hose to Water Tap
Connecting Screw-Type Hose to Tap
).
2
with Thread
Screw the hose connector onto the water supply
tap.
EN