Sony BKSM-T103 Installation Manual page 12

2-1. Installation of Board and Rear Panel
. When the rear panel with 5-pin XLR connectors is used :
(1) Connect the coaxial cable to the BNC connector.
(2) Route the coaxial cable as shown in the figure.
(3) Connect the coaxial cable to CN100 (A-3) on the APR-30 board.
(4) Connect the harness (white) to CN1 on the CP-333 board, and the harness (red) to CN2.
(5) Route the harnesses as shown in the figure.
(6) Connect the harness (white) to CN900 (A-6) on the APR-30 board, and the harness (red) to CN1100
(A-6).
<Connection>
Coaxial cable : BNC connector
Harness (white) : CN1/CP-333 board _ CN900/APR-30 board
: CN2/CP-333 board _ CN1100/APR-30 board
Harness (red)
CN900 (white)
CN1100 (red)
CN100
APR-30 board
2
n
There is no necessity to perform the check/adjustment after the APR-30 board and the ANALOG IN rear
panel installing.
2-4 (E)
_ CN100/APR-30 board
CN900 (white)
CN1100 (red)
CN100
APR-30 board
1
Harness clamper
1 : When the board is installed in "1" side
2 : When the board is installed in "2" side
CP-333 board
CN2 (red)
2
CN1 (white)
BNC connector
CP-333 board
CN2 (red)
1
CN1 (white)
BNC connector
BKSM-T103