Livid Ohm64 Manual page 7

F0 00 01 61 02 07 09 LL HH F7
Request the current mapping of incoming MIDI messages. LL HH is the 8-bit map code defined under
Command 09 below. Both values must not exceed 7F. LL holds the lower 7 bits, HH holds the most
significant bit. Values of HH greater than 1 are reserved. The Ohm64 will respond with Command 09, which
repeats LL and HH followed by the LED code as CR.
07.0A : Request Analog mapping
F0 00 01 61 02 07 0A F7
Request MIDI map for all Analog inputs. The Ohm64 will respond with Command 0A, and the bits are
arranged identically.
07.0B : Request Button mapping
F0 00 01 61 02 07 0B F7
Request MIDI map for all Buttons. The Ohm64 will respond with Command 0B, and the bits are formatted
identically.
07.0C : Request MIDI Basic Channel
F0 00 01 61 02 07 0C F7
Request MIDI Basic Channel. The Ohm64 will respond with Command 0C.
07.0D : Request MIDI Output Merge setting
F0 00 01 61 02 07 0D F7
Request MIDI Output Merge setting. The Ohm64 will respond with Command 0D.
07.0F : Request crossfader Flip setting
F0 00 01 61 02 07 0F F7
Request crossfader Flip setting. The Ohm64 will respond with Command 0F.
08 : MIDI Settings Response
F0 00 01 61 02 08 XX F7
Individual MIDI settings, such as the Channel Mode flags, are combined into the data of this message, XX.
Bit 1 is Omni Mode Off/On. Bit 3 is Local Control Off/On. All other bits, including 0 and 2, are Reserved.
They may reflect other settings, but they may change in future releases. Note that this is a response
command only, and it will be ignored if received by the Ohm64. Use the official MIDI messages to change
these settings.
09 : Map Single LED Indicator
F0 00 01 61 02 09 LL HH CR F7
This command updates the MIDI Input map for a single entry. If HH is 00, then LL specifies the Note
number. If HH is 01, then LL specifies the Control number, but only valid control numbers are accepted
from 00 to 78. Values of HH above 1 are reserved. CR is the LED indicator Column and Row (see