Livid Ohm64 Manual page 6

1.2, 3.3, 5.4, 1.6, 3.7, 5.8, 1.10, 3.12,
2.2, 4.3, 6.4, 2.6, 4.7, 6.8, 2.10, 4.12
Left/Right crossfader:
5.12, 6.12
1-8 Slider 'mute':
1.13, 3.13, 5.13, 1.14, 2.13, 4.13, 6.13, 2.14
BPM:
3.14
The Ohm64 responds with ACK when finished processing this command.
05 : Recall User Settings
F0 00 01 61 02 05 F7
Recall User Settings from storage, just like what happens on power up. The Ohm64 responds with ACK if
the User Settings are valid, or NAK when no setting have been saved or the memory is unreadable.
06 : Factory Reset
F0 00 01 61 02 06 F7
This will erase the User Settings so that the Ohm64 is factory fresh. The Ohm64 responds with ACK when
finished processing this command.
07 : Request
F0 00 01 61 02 07 RR .. F7
This command allows several types of information to be requested. Each request type, RR, will be detailed
below. Some request messages require additional information bytes to specific which particular item is being
requested.
The Ohm64 responds with the specified data.
07.04 : Request all LED indicators
F0 00 01 61 02 07 04 F7
Request state of all LED indicators. The Ohm64 will respond with Command 04, and the bits are interpreted
identically.
07.06 : Request Control Surface Snapshot
F0 00 01 61 02 07 06 F7
Request values for all Analog inputs. The Ohm64 will re-scan every analog input and report the value with
the usual MIDI Channel Message, even if it has not changed.
07.08 : Request MIDI state (Channel Mode, etc)
F0 00 01 61 02 07 08 F7
Request state of settings that are controlled by MIDI messages, such as Local Control, Omni, Mono/Poly
Mode. The Ohm64 will respond with Response Command 08.
07.09 : Request Single MIDI Input mapping