Advertisement
Quick Links
Advertisement
Summary of Contents for Johanson Decibel Clamp wall
- Page 1 Assembly instructions Clamp wall...
- Page 2 Check to make sure that the bracket Secure the bracket in place with is perfectly horizontal. suitable screws. Then mark the position of the fixing screws. Slide the sound absorber into place in the bracket.
- Page 3 Assembly instructions Clamp floor...
- Page 4 40 mm Fit the sound absorber in place on the frame using the 3 wood screws supplied. Make sure that the outside edges of the sound absorber project 40 mm beyond the frame.
- Page 5 Assembly instructions Clamp ceiling...
- Page 6 The sound absorber is supplied with Fit the wires so that the end stops the following components for assebly: slot all the way into the counterbore on the bracket. Bracket 2. Wire with adjustable cable lock (3 pcs) 3. Ceiling fitting 4.
- Page 7 Use the two small wood screws Slide the adjustable wire locks into supplied to secure the sound absor- place on the three wires. To release ber in place on the bracket. the wire, simply press the end of the lock. This makes adjusting the length of the wire easy.
- Page 8 Use the wire locks in the hooks Surplus wire can be snipped to adjust the length and angle. off after the necessary adjust- ments have been made. Installed and ready for use. Installed and ready for use.