Table of Contents
Advertisement
2.3 MIDI Control Change mode
The Parallelizer can be controlled via MIDI Control Changes. Each MIDI Control Change includes a controller number
which specifies the Parallelizer which to turn on or off.
The Parallelizer can select from four different groups of Control Change numbers.
Refer to page 5 'Set Group of Control Change Numbers'.
2.4 MIDI Program Change + Control Change mode
In this mode, the Parallelizer can be controlled via both MIDI Program Change and Control Change.
In other words, on/off combinations can be recalled via the MIDI Program Change and each switch can be switched
on/off via the MIDI Control Change.
3. Set Operation Mode
1. Apply power while holding down FX1 and FX2 switches. The FX1 and FX2 LEDs will flash.
At this moment, the two switches can be released.
2. The four LEDs display the current operation mode.
3. Press Switches FX1, FX2, FX3 and Dry according to this table.
OPERATION MODE
Manual mode
Program Change mode
Control Change mode
Program Change + Control Change mode
(Factory Default)
4. Press and hold the DRY switch to save new Operation mode into the memory.
The Parallelizer will restart automatically.
4. Set MIDI Channel
1. Apply power while holding down FX2 and FX3 switches. The FX2 and FX3 LEDs will flash.
At this moment, the two switches can be released.
2. The four LEDs display the current MIDI channel.
3. Press Switches FX1, FX2, FX3 and Dry according to this table.
MIDI
Channel
1
(Factory Default)
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4. Press and hold the DRY switch to save new MIDI channel into the memory.
The Parallelizer will restart automatically
Parallelizer Owner's Manual
FX1 LED
FX1 LED
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
ON
ON
ON
ON
ON
FX1 LED
FX2 LED
ON
OFF
OFF
ON
OFF
OFF
OFF
OFF
FX1 LED
DRY LED
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
FX3 LED
DRY LED
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
4
Advertisement
Table of Contents
Need help?
Do you have a question about the Parallelizer and is the answer not in the manual?
Questions and answers