Setup And Use Of The Xt Products; Ac Mains Connection - P.Audio XT Series Manual

3. SETUP AND USE OF THE XT PRODUCTS

3.1.

AC MAINS CONNECTION

NOTE: The powered models in the XT series use an automatic switching power supply. ONLY the 3 pin mains power
lead supplied with the unit may be used. DO NOT SUBSTITUTE AC MAINS POWER CONNECTION LEADS.
Prior to connecting the AC mains cable, ensure that the AC mains switch is in the OFF position. The XT range of products will
operate on AC mains voltages of 115 volts to 230 volts. The required AC mains frequency is between 45 Hz and 65 Hz. The
acceptable voltage range is 85VAC-265VAC. The amplifier's switch mode power supply (SMPS) will automatically adjust to the
mains voltage present.
The powered XT enclosures use a standard IEC type connector system. To mate the AC mains cable with the AC mains connector
on the amplifier, simply align the plug with the panel's connector, and push into the connector. Always support the enclosure with
one hand whilst performing this operation. The AC mains connector is shown above. To disconnect the cable end of the AC mains
connector, pull back on the plug to remove. Do not pull on the cable.
NOTE: ALWAYS turn off the AC mains power BEFORE attempting to disconnect the AC mains cable from the XT amplifier
module!
5