Product Profile & Outline; Specifications; Ethernet Interface - Delta Electronics IFD9506 Instruction Sheet

Warning
This instruction sheet only provides introductory information on electrical specification, installation and wiring.
Switch off the power before wiring. DO NOT touch any terminal when the power is switched on.
IFD9506 is an OPEN-TYPE device and therefore should be installed in an enclosure free of airborne dust, humidity,
electric shock and vibration. The enclosure should prevent non-maintenance staff from operating the device (e.g. key
or specific tools are required to open the enclosure) in case danger and damage on the device may occur.
Introduction
Features
1. Auto-detects 10/100 Mbps transmission speed; MDI/MDI-X auto-detection.
2. The monitor table temporarily stores the monitored data for the user to fast save or acquire the data.
3. Supports Modbus TCP protocol (supports Master and Slave mode)
4. Able to send out emails after being triggered.
5. The station address, RS-485 communication format and baud rate can be set up externally.
6. The communication parameters can be set up through Web.
Product Profile & Outline

Specifications

Ethernet Interface

Interface
Transmission method
Transmission cable
Transmission speed
Network protocol
9
RJ-45 with Auto MDI/MDIX
Ethernet Type II
Category 5e, 100m (Max)
10/100 Mbps Auto-Detection
ICMP, IP, TCP, UDP, DHCP, SMTP, Modbus OVER TCP/IP, Delta Configuration
Communication ports: RS-485,
1
Ethernet, RS-232
2
Power indicator
3
Address switch
4
Data format/baud rate switch
5
Digit display
RS-485 indicator, Reset button,
6
Ethernet indicator
7
Module name
RS-485 connector, digital input points,
8
power input point, earth point
9
DIN rail connector
ENGLISH