Advertisement
Advertisement
Table of Contents
Related Manuals for RadioLink R7FG
Summary of Contents for RadioLink R7FG
- Page 1 R7FG (FHSS) INSTRUCTION MANUAL Two-way Transmission PWM&PPM&SBUS Signal Supported 7-channel Receiver with Integrated Gyro...
- Page 2 RadioLink Electronic Ltd www.radiolink.com www.radiolink.com Thanks for purchasing RadioLink 7-channel dual antenna receiver R7FG. To fully enjoy the benefits of this product and ensure safety, please read the introduction carefully and set up the device as instructed steps. If any problems found during the operation process, please kindly refer to the manual first. Then you could contact our distributors to find solution or follow our Facebook homepage https://www.facebook.com/RadioLink-1455452961436694/...
-
Page 3: Table Of Contents
RadioLink Electronic Ltd www.radiolink.com Content I. R7FG Introduction ......................... 1 1.1 Compatible transmitters ....................1 1.2 Binding ..........................1 Telemetry ..........................2.1 Telemetry of Signal and RSSI ..................2 2.2 Telemetry of Model Battery and Receiver Voltage ............2 III. Subsidiary ID ........................3 IV. -
Page 4: R7Fg Introduction
RC4GS - V6.0.1 (Compatible with RC4GS produced AFTER Jan.1, 2018 ONLY) The other models RC6GS with 2-position switch, RC4GS produced before 20180101, T8FB, T8S, RC3S and RC4G can bind to R7FG though the functions of 2-way transmission and subsidiary ID can’t be realized. -
Page 5: Telemetry
Note: ⚫ NO gyro by default as factory setting. Since integrated gyro in R7FG will self-check, it is very important to remain R7FG still when powering it on. There are two LED indicators on R7FG. GREEN LED (always on) indicates normal working mode while GREEN+RED LEDs (always on) indicate gyro working mode. -
Page 6: Subsidiary Id
Model battery voltage telemetry can be easily achieved by connecting the male end of the battery wire to ESC while the female end to the battery and the wire with a JST head connects BAT (+-) of R7FG/R8F as below pic shown. No extra module is needed. -
Page 7: Working Modes
Once finished , the corresponding ID number will be displayed on the RC6GS main interface . Then the other receivers can be bounded as the same way with the following numbers. IV. Working Modes R7FG has four working modes:... -
Page 8: Gyro Introduction
5.2 Gyro Parameter A. Gyro Enabled Factory setting is gyro function OFF by default. When power on R7FG, the gyro will self check. There are two indicators on R7FG while always-on GREEN LED is working mode WITHOUT gyro and always-on GREEN+RED LED is working mode WITH gyro. -
Page 9: Transmitter Sensitivity Adjustment
Percentage is displayed when sensitivity is adjusted while the bigger percentage means higher sensitivity. If the VR rotary switch/CH3 is set with other function, menu setting on transmitter can be used to adjust gyro sensitivity. VI. R7FG Specifications 1）Frequency：2.4GHz ISM band(2400MHz~2483.5MHz) 2）Dimension: 35*20*13mm 3）Weight: 6g... - Page 10 Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make the receiver out of control. When all the above steps are complete, please turn off the transmitter and repower on to test if the receiver is correctly bind with it. Thank you again for choosing RadioLink product.