Download Print this page

Mitsubishi Electric LM55P4 User Manual page 5

Lcd display monitor

Advertisement

WARNING:
Unplug immediately if there is something
wrong with your product.
Do not operate if smoke, strange noise or odor
comes out of your product. It might cause fire or
electric shock. In this case, unplug immediately
and contact your dealer.
Do not modify this equipment.
It can lead to fire or electric shock.
Use the attached specified control cable.
Use the optional specified power supply cord.
This apparatus must be grounded.
Use an earth leakage circuit breaker to
supply power.
Do not use the product under the following
circumstances, which may cause fire or
electric shock.
● in a dusty or humid place
● near a heater
● in a oily, smoky or damp place
● in direct sunlight
● where the air vents are directly exposed to the
air from an air conditioner
● where the product is frequently exposed to
vibrations
● with high temperature, such as the closed car
● where the temperature is lower than 5˚C (41˚F)
or higher than 35˚C (95˚F)
● where any corrosive gas i.e. SULFIDE-
CONTAINING-GAS is produced.
Don't expose the LCD panel to impact.
The LCD panel may be damaged, causing injury or
breakdown.
For the control terminal, use an Ethernet
cable only.
For your safety, connect to an Ethernet network
which does not exceed the voltage limit of the
Ethernet connector.
Do not use this product outdoors.
This product is designed for indoor use.
Do not install this product upside down, on
its rear, face down, or in a slanting position.
Do not get the liquid crystals in your mouth.
If the LCD panel is damaged and the liquid
crystals leak out, do not inhale or swallow them
because they are highly toxic. If you should
accidentally get them in your eyes or mouth, rinse
with water and see a doctor immediately.
If the liquid crystals get on your skin or clothes,
wipe them off using alcohol and then rinse with
water.
CAUTION:
Battery replacement of the optional remote
control DP-02RK.
Improper use may result in fire, injury, or
spread dirt due to leakage, heat generation,
or explosion.
● Replace all the batteries with new ones. Use two
AAA batteries (R03).
● Load the batteries with their (+) and (-) sides
correctly.
● Load the batteries from (-) sides first.
Please, dispose of this equipment, batteries
and accumulators correctly at your local
community waste collection/recycling centre.
NOTE:
This symbol mark is for EU countries only.
This symbol mark is according to
the directive 2012/19/EU Article 14
Information for users and Annex IX,
and/or to the directive 2006/66/EC
Article 20 Information for end-users
and Annex II.
Your MITSUBISHI ELECTRIC product is
designed and manufactured with high quality
materials and components which can be recycled
and/or reused.
This symbol means that electrical and electronic
equipment, batteries and accumulators, at their
end-of-life, should be disposed of separately from
your household waste.
If a chemical symbol is printed beneath the symbol
shown above, this chemical symbol means that the
battery or accumulator contains a heavy metal at
a certain concentration. This will be indicated as
follows:
Hg: mercury (0,0005%), Cd: cadmium (0,002%),
Pb: lead (0,004%)
In the European Union there are separate
collection systems for used electrical and electronic
products, batteries and accumulators.
Please, dispose of this equipment, batteries and
accumulators correctly at your local community
waste collection/recycling centre.
Please, help us to conserve the environment we
live in!
EN-5

Advertisement

loading

This manual is also suitable for:

Lm55p4w