3.3. Adapting for 300
equipment)
To bevel pipes with diameters of 300–600 mm (10–24''), assemble the guide set
using an optional guide. To do this, remove the guide set (1, 2, Fig. 6), use the 4 mm
hex wrench to unscrew the standard guide, and assemble the guide for 300–600 mm
pipes (Fig. 10), tightening with the screws. Mount the rollers and adjust the required
bevel angle and width as described before.
Part number:
PRW-0505-03-00-00-0
Fig. 10. Machine prepared for work on pipes with diameters 300–600 mm
Copying, using, or distributing without permission of PROMOTECH is prohibited.
–
600 mm pipes (requires optional
This document is protected by copyrights.
13
BM-21S