Karakoram CONNECT SPLIT CONVERSION KIT Assembly And Use Instructions

SPLITBOARD TRANSITION- TOURING
1
TURN DUAL RIDE-STRIDE 90° TO STRIDE POSITION
RIDE STRIDE
2
PUT BINDING IN TOUR MODE 3
4
OPEN
CLOSED
SPLITBOARD TRANSITION- RIDING
1 JOIN SPLITBOARD
2
TURN DUAL RIDE-STRIDE TO A RIDE POSITION
3
DROP-ON BINDING TO RIDE MODE
5 IT'S TIME TO RIDE!
RIDE STRIDE
ENJOY THE SCENIC WALK UP
ADJUST SINGLE RISER AS NEEDED
0° or 15°
10°-22°
4
CLOSE LEVER
PRIME SYSTEM PARTS INCLUDED:
Ride Mode 2.0 Ride Mode 2.0
6x M6x10mm Buttonhead Screw
Tour Mode
M6x8mm Buttonhead Screw
10x
4x for DualSpeed Risers
6x for Tour Mode with thin core boards
M6x14mm Flathead Screw
8x
Ride Mode 2.0 (attached to card)
For binding size adjustment and installation videos
please visit:
www.splitboardbindings.com/manuals-and-instructional-videos
TOUR ADAPTER INSTALLATION
1 Cut EVA Toe Ramp off
with box knife
2
Remove forward screws
CLOSED
1
2
OPEN
CONNECT SPLIT CONVERSION KIT
Assembly and Use Instructions
Patented US8469372B2, US8733783B2 and Patents Pending
Tour
Tour
Single
Adapters Mode
Risers
4x
M5x10mm Buttonhead Screw
Tour Adapter
4x
M5 Nylock Nut M5 Nylock Nut M5 Nylock Nut
Tour Adapter Tour Adapter Tour Adapter
M4 Hex
4x
Interface Screws
M5x18mm Buttonhead Screw
Tour Adapter
Disclaimer: Disclaimer:
Snowboarding is an inherently dangerous and hazardous
sport and can result in serious injury or death. Karakoram
shall have no liability for injuries sustained by use or mis-use
of this product. The user takes full responsibility for learning
proper backcountry travel and avalanche safety.
3
Attach Tour Adapter with
forward screws
Install M5x10mm Buttonhead Screws
4
and M5 Nylock Nuts
4
3