WAGNER W14 Operating Instructions Manual page 14

Steam wallpaper stripper
Hide thumbs Also See for W14:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
EN
Caution!
Warning: Hot liquid or steam can burn. Danger of scalding. Steam may
also condense into boiling droplets. Steam should not be directed towards
electrical appliances. Danger of scalding appears on the cap as either symbol.
Beware of steam - before removing the filler cap and refilling unit. When
finished, allow to cool completely and empty unit. Always store unit empty.
Before loosening the filler cap always allow the unit to cool down
for at least 2 minutes. Caution! Risk of scalding! (Fig. 11).
Heated water can leak from the steamplate during the heating-up
phase. Hot water can drip during overhead work.
Model
Boiler Capacity
W16
5L
W14/W15
4L
*Approx steam time before the safety cut-out operates.
Descaling
Regular descaling is key to your steamer functioning properly.
i
Depending on water hardness, descale the steam wallpaper stripper
after 10 – 15 fills. Units which are defective due to a lack of descaling
are excluded from the guarantee!
Use a standard proprietary descaling agent. Observe the manufacturer's instructions
for use!
Mix the descaling agent with water (ratio 1:1).
Fill the steam wallpaper stripper with around 2.5 litres of descaling solution.
Switch the steam wallpaper stripper on for 10 minutes.
Switch the steam wallpaper stripper off again and disconnect the mains plug.
Leave the descaling solution to work for 30 minutes.
Then fully empty the steam wallpaper stripper.
Thoroughly rinse the unit two to three times with clear water to remove all descaling
solution residue.
Storage
Store emptied, upright and dry.
14
2358534 0615 W14/W15/W16 D/GB/FR/NL/IT.indd 14
Steam Time
80 Minutes*
70 Minutes*
W14/W15/W16
17/06/2015 15:26

Advertisement

Table of Contents
loading

This manual is also suitable for:

W15W16

Table of Contents