Verbatim External Hard Drive User Manual page 6

Depending on your computer's operating system and the interface type you
are using, the following special notes may apply:
Note 1: USB under Windows 98 SE. If you are using Windows 98
SE and you are connecting via USB, you will need some additional
software that you can download from the Verbatim web site. Refer to
the Getting Help section.
Note 2: FireWire under Windows 98 SE. If you are using Windows
98 SE and your computer prompts you to insert the Windows 98 SE
Installation CD after connecting your hard drive, this means you need to
install additional FireWire (1394) support software from Microsoft. You
should disconnect your hard drive, then locate, download, and install
the latest FireWire (1394) drivers for Windows 98 SE from the Microsoft
website http://windowsupdate.microsoft.com.
Note 3: USB under Windows. If you are using a USB 1.1 port on your
Windows computer, the following cautionary note may appear on your
display: Hi-Speed USB Device plugged into non-Hi-Speed USB hub.
This does not indicate a problem because the Combo Hard Disk drive
is compatible with both USB 1.1 and USB 2.0 ports. Simply close the
message and proceed. However, in this case the Combo Hard Disk
drive will operate only at USB 1.1 speeds.
Note 4: USB under Mac OS 9.2.x. Mac OS versions 9.2.x do not support
USB 2.0 Hi-Speed mode. For these Mac OS versions the Combo Hard
Disk drive will operate only at USB 1.1 speeds.
Note 5: USB or FireWire under Mac OS X 10.2. Mac OS X version 10.2
will not mount any single FAT32-formatted (MS-DOS) partition greater
than 128GB. To work around this OS limitation, you may partition the
drive into smaller FAT32 partitions, or you may reformat the drive to
HFS+ format.
6