Page index What is Eagle 1500? ............2 How do I setup the Eagle 1500? ........3 How do I setup the Eagle 1500 using WPS? ....5 How do I change the network name? ......6 Where should I place the Eagle 1500? ......7...
Setup of Eagle 1500 are done in just a few steps. The setup of Eagle 1500 can be done from your computer, smart phone or pad, but we recommend that you use a cable connection between your computer and the Eagle 1500.
How do I setup the Eagle 1500? 1. Connect the Eagle 1500 to a power outlet near the exisiting wireless router (about 3 meter). 2. Connect the Eagle 1500 to your computer using the enclosed network cable. 3. Open your WEB browser (Internet Explorer, Chrome etc.) and enter the address Enter the address http://jensen.setup and click enter.
Page 4
6. Enter the password for your existing wireless network and click Save. 7. Click OK 8. The Eagle 1500 will now do a reboot and try to connecting to your wireless network. 9. After the reboot you will get a message if the connection was successfull or not.
WPS. 2. Click the WPS button for 2 seconds on the Eagle 1500 and then do the same on your wireless router. The Eagle 1500 will now try connecting to your wireless network (This usually takes about 30-60 seconds) 3.
3. Log in with the password 1234 4. Click Wireless -> Wireless Basic Settings 5. Extended Access Point name is the name of the wireless network transmittet from the Eagle 1500. Enter the new network name (AirLink7000_livingroom in our example).
Where should I place the Eagle 1500? In order for the Eagle 1500 to function as good as possible it is important that you place it so it can receive a fairly good signal from the existing wireless network. We recommend that you avoid placing the Eagle 1500 near TV, speakers, wireless phones etc.
How do I reset the Eagle 1500? If you have some problems or want to setup the Eagle 1500 to another wireless network you can reset it by following the below steps: 1. Connect the Eagle 1500 to a power outlet and wait for 20 seconds.
Please make sure you enter the correct password/encryption key for the wireless network that the Eagle 1500 shall connect to. If you still have problems with your Eagle 1500 we recommend to do a reset and try setup again. Internettmodem...
How to check the connection status To check the connection status of Eagle 1500 you can either look at the LED or you can login and see the status page. Check LED connection status: 1. When the Eagle 1500 is connected to a network the RE LED will lit.
LED and connections on the Eagle 1500 RE (Range Extender) LED Signal LED WPS button LAN LED (ethernet port LED) Power LED Reset button Ethernet port (10/100Mbps) Color LED status Steady green Strong signal Weak signal Steady orange Signalstyrke no signal / not connected...
1. Download the latest Eagle 1500 firmware from www.jensenscandinavia.com/downloads 2. Unzip the firmware file to e. g. desktop 3. Connect the computer to the Eagle 1500 using a network cable. 4. Open a WEB browser and enter the address http://jensen.setup 5. Password = 1234 6.
In order for us to give you the best help quality, please include following information in your e-mail: * Which Jensen product do you have? * Which other products do you use in combination with your Jensen product? * A full description of the problem Normally we will reply to your request within one working-day.
Need help?
Do you have a question about the Eagle 1500 and is the answer not in the manual?
Questions and answers