Using Headphones / Earphones; Installation - Venturer 15" LCD TV PLV7615H Instruction Manual

USING HEADPHONES / EARPHONES

• Turn down the volume before connecting
headphones / earphones to the unit, then
adjust the volume to your desired level.
• When headphones / earphones are
connected, no sound will come from the
front speakers.
NOTE
Excessive sound pressure from headphones
/ earphones can cause hearing loss.

INSTALLATION

INSTALLING / REMOVING THE BASE STAND
WARNING: The LCD Display is very fragile, and must be protected
at all times when removing the base stand. Be sure that no hard
or sharp object, or anything that could scratch or damage the LCD
display, comes into contact with it. Do NOT exert pressure on the
front of the unit at any time because the screen could crack.
1. Disconnect all cables or cords connected to the unit.
2. Lay the unit down on a fl at surface with the back side facing
up. Please make sure to place a soft cushioned material (such
as a pillow or thick piece of foam) beneath the screen.
3. To install the base stand, place the base stand on the mounting
slot, push the stand till it locks.
4. To remove the base stand, keep pressing the locking area of the
base stand and pull downwards to release the base stand.
MOUNTING THE TV UNIT
1) Mark the correct mounting position on the wall.
2) Insert a fi xing screw(s) at the marked position on the wall.
3) Align the slot hole(s) of the speaker over the screw and pull the TV
downward until it is fi rmly hooked.
NOTE
Remove the base stand before mounting the unit on the wall.
PLV76156S7_ENG_IB_UL_091221.indd 9 PLV76156S7_ENG_IB_UL_091221.indd 9
Press and pull downwards
E - 9
12/22/2009 10:46:14 12/22/2009 10:46:14