Operating The Video Recorder - Dometic Perfectview REC400 Installation And Operating Manual

Operating the video recorder

9 Operating the video recorder
9.1 Making video recordings
I
NOTE
• To start operating the video recorder, an SD card with at least 4 GB
of memory capacity must be inserted first.
• The video recorder switches on automatically as soon as voltage is
supplied. It is not possible to switch it on and off manually.
Starting recordings
➤ Insert the SD card into the slot in the video recorder (fig. 3 5, page 4).
➤ Switch on the ignition.
After approximately 30 seconds, the starting process is complete. The red LED lamp
begins to flash during the starting process and the video recorder starts recording.
I
NOTE
If you switch on playback mode, the video recorder will stop recording.
Ending a recording
➤ Switch the video recorder off by disconnecting the voltage or starting playback.
9.2 Deleting all videos
You can delete recorded data under the menu item "Delete All Recorded Data".
➤ Select the required sub-item (see chapter "Navigating through menus" on
page 14).
➤ Make a selection using
➤ Confirm by pressing
✓ All recorded data will be deleted.
20
or .
.
REC400
EN