Task Lighting Sempria LED Q Series Installation Instructions page 2

INSTALLING FIXTURES
1. Slide lens back to expose connectors or remove lens from fixture.
2. Strip ¼" from Red wire and insert into terminal block opening with Red marking. Strip Black wire, insert into terminal
block opening with Black mark.
3. Cut wires to fit between adjacent fixtures. Insert wires into terminal blocks, maintaining polarity (Red wire to Red terminal,
Black wire to Black terminal.) MAINTAIN POLARITY OR THE FIXTURE WILL NOT WORK.
4. If fixture does not light, reverse wires.
5. Mounting surface must be finished and dust-free for mounting tape to properly adhere. Remove backing from mounting
tape and press fixture firmly into place.
6. Using screws provided, secure fixture in place. DO NOT pierce LED strip with screws, nails, staples, or any other
mechanical device.
7. Slide or snap lens back into place.
NOTE:
If using stranded wire we recommend tinning the end of the wire first. If stranded wire is used without tinning, terminal block
tabs must be depressed when inserting wires. Note that wiring with untinned stranded wire may result in a poor connection.
S-Q&E-S ERI E S - IN S TA L L - 0 5 1 7
Sempria
Installation Instructions
WHEN USING TWO DRIVERS:
Start both sets of wires
from drivers at a common
point and wire the zones in
opposite directions.
800.445.6404 tasklighting.com
•
LED Q & E Series
®
15vDC
Driver #1
D
$
Driver #2
D
120V Switch
21