Download Print this page

Plantronics CT10 User Manual page 11

Telephone
Hide thumbs Also See for CT10:

Advertisement

Available languages

Available languages

CT10MultiLangInside.R1
7/3/00
STEP 1
SETUP THE HEADSET
Put on the Headset
, and adjust the band until it rests with almost no
1
pressure on your ear and the top of your head.
If the headset is too loose, remove it and gently push the headset band
inward slightly to tighten it. If the headset is tight, gently pull the headset
band out to loosen it.
The microphone boom can be swiveled to position the headset on either
your right or left ear by rotating it up over the head.
Use one hand to hold the headset in place. Adjust the microphone boom
until it is about 1 inch from the side of your mouth. Do not twist the
microphone on the end of the boom as this may damage the internal
wiring.
Use the Clothing Clip
to attach the headset cord to your lapel or collar
2
and out of your way.
Leave enough slack in the headset cord so that you can move your head
freely.
PULSE/TONE SWITCH
The Pulse/Tone Switch
is located under the Base
33
switch to Pulse or Tone as desired or required by your telephone service.
2:21 PM
Page 8
F
F
simply push the
19
8
STEP 2
MAKE A CALL
Before using your cordless telephone, put the headset on and adjust it
as needed.
To make a call, press the Talk/Hangup Button
The In-Use Indicator
will light.
10
When you hear dial tone, enter the number you want to call.
To disconnect a call, press the Talk/Hangup Button
STEP 3
RECEIVE A CALL
Set the Ringer Switch
on the Remote
to the ON position.
17
3
To answer a call press the Talk/Hangup Button
Indicator
on the Remote and the In-Use Indicator (Talk)
10
Base
will light.
19
When you press any button on the Remote, a short sound will be heard
indicating that the Base has accepted the command.
Three short warning beeps indicate that you are out of range, or there
is too much interference.
If there is interference, move closer to the base before you press any
key. If interference is severe, the Remote might lose communication with
the Base and the call might be disconnected.
This does not happen often, but if it does, return the Remote to the
Charging Well for a few seconds.
9
F
on the Remote
.
11
3
G
.
11
G
. The In-Use
11
on the
22

Advertisement

loading