1. Manuals
  2. Brands
  3. Remotec Manuals
  4. Repeater
  5. ZRP-200
  6. Manual

Remotec ZRP-200 Manual

Z-wave plus slim repeater
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ZRP-200
Z-Wave Slim Repeater

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZRP-200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Remotec ZRP-200

Summary of Contents for Remotec ZRP-200

  • Page 1 ZRP-200 Z-Wave Slim Repeater...

  • Page 2: Table Of Contents

    3. Get Started a. Open the box b. Step 1 Apply Power to ZRP-200 c. Step 2 Include ZRP-200 to a Z-Wave Gateway d. Step 3 Setup Automatic Status Report Association to Gateway 4. Health Channel Checking 5. Reset to Factory Default 6.

  • Page 3: Introduction

    ZRP-200 INTRODUCTION Thank you for choosing ZRP-200 Range Booster product. ZRP-200 is a Z-Wave repeater with best RF performance to replicate Z-Wave signals in a network. The repeater re-transmits an input Radio Frequency (RF) signal by routing the signal around obstacles and radio dead spots to ensure that the signal is received at its intended destinations.

  • Page 4: Z-Wave Glossary

     Simply plug the Z-Wave Slim Repeater in ITE Approved Regulated 5VDC USB Power Adaptor.  Blue indicator will flash twice then flash continuously. 1, If ZRP-200 has been included to the network, it will only flash twice of the Blue indicator then OFF.

  • Page 5: Step 2 Include Zrp-200 To A Z-Wave Gateway

    RESET TO DEFAULT) Health Channel Checking This feature is only to check the connectivity between the Z-Wave Slim Repeater and the Gateway. Before use this feature, make sure the ZRP-200 has been included in the network. Step Procedure / Description Status Indicator Press once of the “PROG”...

  • Page 6: Reset To Factory Default

    Installation Location Tips  Avoid installed near the metallic objects  Install the ZRP-200 about 1.5m at least above the floor. Setting it on a higher position can provide a better signal repeating capability  Avoid installing above or near hot surface or equipment. Avoid installing the device where it will be exposed to direct sunshine.
  • Page 7 All warranty claims must be made to Remotec appointed distributors or dealers during the applicable warranty period. This warranty gives you specific legal right and you may also have other rights which vary in each country.
  • Page 8 ZRP-200 Regulatory information FCC ID : M7N-BW8180 FCC Compliance Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
  • Page 9 ZRP-200 Caution - Risk of explosion if battery is replaced by an incorrect type. - Dispose of used batteries according to the instructions.

Table of Contents