Table of Contents
Advertisement
Quick Links
Wireless Z-Wave Control
ZRP-100US
Z-Wave Repeater
USER MANUAL
Introduction
Thank you for choosing ZRP-100 Z-Wave Repeater product! ZRP-100 is a Z-Wave
repeater with best RF performance to repeat Z-Wave signals in a network, which will
re-transmit the RF signal to ensure that the signal is received by its intended
destination by routing the signal around obstacle and radio dead spots.
Page 1 of 8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Remotec Z-Wave ZRP-100US
Summary of Contents for Remotec Z-Wave ZRP-100US
- Page 1 Wireless Z-Wave Control ZRP-100US Z-Wave Repeater USER MANUAL Introduction Thank you for choosing ZRP-100 Z-Wave Repeater product! ZRP-100 is a Z-Wave repeater with best RF performance to repeat Z-Wave signals in a network, which will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacle and radio dead spots.
- Page 2 Glossary Device/Light/Node Devices, lights and nodes are all terms to describe an individual Z-Wave device. These are all interchangeable when setting up your Z-Wave network. Z-Wave Network A collection of Z-Wave devices is controlled by primary and secondary controllers operating on the same system. A Z-Wave network has its own unique ID code so that controllers not in the network cannot control the system.
- Page 3 Product Overview Status LED PROG Push button Fixing hole AC plug External fixing insert and screw Installation Location WARNING: To avoid fire, shock, or death; turn off power at circuit breaker or fuse and test that power is off before dismount or mount the unit by screw! In case you need to mount the unit with screw, please refer to below figures and select your configuration.
- Page 4 ZRP-100 will not block lower outlet when plugged into upper outlet of a duplex wall receptacle and vice versa. Below are the illustrations. Un-grounded AC outlet Grounded AC outlet Grounded AC outlet with with center screw with center screw upper and lower screw Installed at upper AC outlet Installed at lower...
- Page 5 Z-Wave setup and operations Z-Wave inclusion and exclusion Include or exclude the ZRP-100 from the existing Z-Wave home control network with your primary controller. Refer to your primary controller instructions to process the inclusion / exclusion setup procedure. When prompted by your primary controller, triple click the PROG button within 1 second. (The unit will enter classical inclusion/exclusion first then jump to NWI, it will exit NWI mode automatically after 5 seconds if no inclusion/exclusion request.) The primary controller should indicate that the action was successful.
- Page 6 Wireless Information Wireless range: This device has an open-air line-of-sight transmission distance of 30m which complies with the Z-Wave standards. Performance can vary depending on the amount of objects in between Z-Wave devices such as walls and furniture. Every Z-Wave device set up in your network will act as a signal repeater allowing devices to talk to each other and find alternate routes in the case of a reception dead spot.
- Page 7 Certifications UL Listed: This power unit is intended to be correctly orientated in a vertical or floor mount position. FCC Information FCC ID : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired...
- Page 8 All warranty claims must be made to Remotec appointed distributors or dealers during the applicable warranty period. This warranty gives you specific legal right and you may also have other rights which vary in each country.
Need help?
Do you have a question about the Z-Wave ZRP-100US and is the answer not in the manual?
Questions and answers