Advertisement
Start-Up Procedure
Placing unit into service
Normal
Operation
Mode Icon
Flush the filter with water: Locate the nearest cold water faucet tap and open it. If there is
a water softener installed downstream of the filter, close it's bypass valve until this step is
completed. Slowly open filter bypass valve and let water run to the open faucet tap until it
runs clear. This will flush any media residual from the filter and prepare the unit for ser-
vice. Re-open bypass (if installed).
Proceed to setting current time of day.
While in service, the Data Display alternates between time of day,
volume remaining or days to regeneration.
The Flow Indicator flashes when outlet flow is detected.
The Faucet Icon flashes if a regeneration cycle has been queued.
Advertisement
