Subscribe to Our Youtube Channel
Related Manuals for Water Control Corporation BrassMaster plus+
Summary of Contents for Water Control Corporation BrassMaster plus+
- Page 1 Metered Water Softener Installation / Operation manual Manufactured by: Water Control Corporation 7150 143rd Ave NW Ramsey, MN 55303 Tel: 763-427-9635 Fax: 763-427-5665...
- Page 2 Installation procedure 1. Identify installation location for water softener. Piping should be such that all household water, with the exception of outside hydrants, flows through softener. A hard water line may be run to a kitchen tap if so desired. This system and installation must comply with state and local laws and regulations.
- Page 3 Start-up procedure Placing unit into service • Fill the mineral tank with water: Press and hold the extra cycle button for 5 seconds. Display will indicate step 1, which is the backwash cycle (as shown above). Once the display indicates step 1, slowly open bypass valve and let water run to the drain for approximately 5 minutes.
- Page 4 Start-up procedure Setting current time Setting time of day 1. Press either the Up or Down buttons to adjust current time of day by one digit. Push and hold either up or down set button to adjust current time of day display by several digits.
- Page 5 Start-up procedure User programming (Cont’d) 3. Adjust Regeneration Time: Press the Extra Cycle button. This setting determines the time of day that the unit will enter the regeneration cycle. The most common / default set- ting is 2:00 AM. 4. Set Water Hardness: Press the Extra Cycle button. Set the hardness of the incoming wa- ter.
- Page 6 Warranty / Maintenance information All BrassMaster Plus water softeners feature the Assured Performance Modular (APM) design. If you experience a failure of any valve component, the brass module can be easily removed and replaced with a factory remanufactured replacement module. To remove module, index the bypass valve to its “Bypass”...
-
Page 7: Limited Warranty
Limited Warranty Water Control Corporation warrants the control valve to be free of manufacturers defects for a period of 5 (five) years from the date of installation, and the fiberglass reinforced mineral tank, and plastic brine tank, to be free from leaking due to manufacturers defects for a period of 5 (five) years. - Page 8 Manufactured by: Water Control Corporation 7150 143rd Ave NW Ramsey, MN 55303 Tel: 763-427-9635 Fax: 763-427-5665...
Need help?
Do you have a question about the BrassMaster plus+ and is the answer not in the manual?
Questions and answers