GENERAL SAFETY RULES Safety is a combination of common sense, staying alert, and knowing how your chipper shredder works. SAVE THESE SAFETY INSTRUCTIONS. WARNING: To avoid mistakes that could cause serious injury, do not plug in pressure washer until the following steps have been read and understood. WARNING: This appliance is not intended for use by children or by unassisted, unsupervised persons whose physical, sensory or mental capabilities prevent them from using it safely.
SPECIFIC SAFETY RULES FOR PRSSURE WASHER WARNING: Do not operate your pressure washer until it is completely assembled and installed according to the instructions. It is very important to bleed the gun before using the pressure washer. Squeeze the trigger to allow any air that is trapped inside of the unit and hose to escape.
ELECTRICAL INFORMATION Grounding instructions IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides the path of least resistance for electric current and reduces the risk of electric shock. This tool is equipped with an electric cord that has an equipment grounding conductor and a grounding plug. The plug MUST be plugged into a matching outlet that is properly installed and grounded in accordance with ALL local codes and ordinances.
Page 7
ELECTRICAL INFORMATION (CONTINUED) Guidelines for using extension cords Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
KNOWING YOUR PRESSURE WASHER Wheel Hose reel handle Water outlet Detergent tank Hose reel Power cord ON/OFF switch Adjustable spray wand Water inlet...
ASSEMBLY AND ADJUSTMENTS Unpacking Unpack the chipper shredder and all its parts, and compare against the list below. Do not discard the carton or any packaging until the chipper shredder is completely assembled. Adjustable wand High pressure wand Inlet quick connector Connect high pressure hose 1.
ASSEMBLY AND ADJUSTMENTS (CONTINUED) Connect the garden hose to pressure washer Connect the garden hose adaptor (female coupler) to the water inlet of the pressure washer, then thread your garden hose (male end) into the garden hose adaptor. You may need take the male connector of from the quick connector. The garden hose must have an internal diameter of at least 13 mm (1/2 in.) and must be reinforced.
Page 11
OPERATION (CONTINUED) Using the adjustable wand WARNING! High-pressure jets can be dangerous if subject to misuse. The jet must not be directed at persons, pets, live electrical equipment, or the appliance itself. 1. The washer is equipped with an adjustable nozzle. 2.
Page 12
OPERATION (CONTINUED) 6. Rinse with clean water under high pressure. When working on a vertical surface, rinse from the bottom up, then rinse from the top down to avoid streaking. Hold the nozzle 6-8 inches away from the work surface at a 45° angle. 7.
Storage CAUTION! Always store your pressure washer in a location where the temperature will not fall below 32ºF (0ºC). The pump in this machine is susceptible to permanent damage if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE WARRANTY. Store the pressure washer indoors in a dry, covered area where it is not subject to adverse weather conditions.
MAINTENANCE WARNING! Before working on the pressure washer, disconnect the plug from the power supply socket. 1. To ensure good performance, check and clean the water inlet filter. Remove the filter and rinse with warm water to prevent any foreign matter from clogging the pump. 2.
EXPLODED VIEW & PARTS LIST Item Stock # Description Item Stock # Description PS20-101 Water outlet PS20-123 O-ring 21x1.9 PS20-102 O-ring 22x2.4 PS20-124 Connecting cap PS20-103 Spring PS20-125 left cover PS20-104 End housing PS20-126 Slide block PS20-105 O-ring 5x1.8 PS20-127...
Page 16
EXPLODED VIEW & PARTS LIST (CONTINUED) Item Stock # Description Item Stock # Description PS20-201 Front cover PS20-223 Screw ST4x25 PS20-202 ON/OFF switch PS20-224 Washer PS20-203 Switch cover PS20-225 Wheel PS20-204 Front housing PS20-226 Wheel right cover PS20-205 Handle PS20-227...
Page 17
ONE (1) YEARS LIMITED WARRANTY ® PowerSmart is committed to building tools that are dependable for years. Our warranties are consistent with our commitment and dedication to quality. ONE (1) YEAR LIMITED WARRANTY OF POWER SMART PRODUCTS FOR HOME USE.
Need help?
Do you have a question about the PS20 and is the answer not in the manual?
Questions and answers