Rear Panel - Sony SRP-P50 Operating Instructions Manual

LOCATION AND FUNCTIONS OF PARTS

REAR PANEL

5INPUT terminals
6OPERATION switch
7INPUT LEVEL selector switches
8BAL/UNBAL selector switches
5 INPUT terminals
Inputs signals to the unit from the mixer, AV equipment,
etc.
CH1 INPUT (MONO) : During stereo operations, serves
as the CHANNEL 1 input terminal. During monaural
operations, connect here.
CH2 INPUT : During stereo operations, serves as the
CHANNEL 2 input terminal. During monaural
operations, this is separated from the signal path.
XLR connector (Equivalent to XLR3-31) : When the
BAL/UNBAL switch is set to BAL, balanced type
signals are input.
Adjust together.
Phono jack (Unbalanced type) : When the BAL/
UNBAL switch is set to UNBAL, signals are input
from the Phone jack .
Pin 3 of the XLR connector is short-circuited to
ground inside to receive UNBAL signals.
6
Press here to release
STEREO BAL 0dBs
MONO UNBAL -10
LEVEL
OPERATION CH2 INPUT
BAL/UNBAL
CH1 INPUT (MONO)/CH2 INPUT
XLR connector
switch
Balanced type
BAL side
2
3
UNBAL side
(unbalanced)
6 OPERATION switch
Switches between stereo and monaural. During stereo
operations, set to STEREO. During monaural operations,
set to MONO, and at the same time, change the speaker
terminal wirings.
Be sure the Power switch is turned off before
setting this switch.
UNBALANCED
0dBs BAL
(STACKING)
-10 UNBAL
LEVEL
CH1 INPUT(MONO)
Phono jack
1: GND
OFF
1
2: HOT
3: COLD
ON
ON