Advertisement
ASSEMBLY & COMMISSIONING IN GENERAL
BEFORE START-UP
Seal the supplied plug nipple with Teflon tape and then screw it into the compressed air connec -
tion.
Operate the compressed air unit only with an oiler.
Pressure reducer must be present on the compressor.
Install a water separator (filter) before the oiler.
The maximum operating pressure of your air tool is 6.2 bar. If you set your pressure minimum
higher than 6.2 bar, your air tool may be overloaded.
During longer breaks in operation, we recommend cleaning and lubricating the air tool thoroughly.
When the unit is put back into operation, add some compressed air oil to the connection of the
compressed air unit, let the unit run for a short time, then operate it with a compressed air lubrica -
tor. Some units are equipped with an infinitely variable regulation for speed and impact force. (e.g.
impact wrench, drill left/right barrel, chisel hammer set, random orbit sander, etc.) This adjustment
screw is located directly next to the air seal of the unit.
TOOL: IMPACT WRENCH
FIGURE
a) Square for nut holder
b) Return lever (left/right rotation)
c) Trigger lever
d) Air controller or torque controller
e) Compressed air connection
INTENDED USE
The impact wrench is suitable for tightening and loosening
screw connections using compressed air.
Do not use impact wrenches for purposes other than their intended purpose.
Secure pneumatic tools against children!
Only to go to work rested and concentrated.
Compressed air connection only via a quick-release coupling
Working pressure adjustment must be carried out via a pressure reducer.
Do not use oxygen or flammable gases as energy source.
Before any maintenance, adjustment or cleaning work, disconnect the unit from the compressed
air source!
Only use original spare parts!
Never run unloaded at full idle speed.
Wear the necessary protective clothing when working with the impact wrench.
START-UP
Screw the supplied plug-in nipple into the compressed air connection (E) and seal it with Teflon
tape!
Insert the required plug-in attachment onto the square (A). Set the correct direction of rotation on
the reversing lever (B):
Drücken nach hinten (REVERSE) Linkslauf = Schraube lösen
o
Push forward (FORWARD) clockwise = tighten screw
o
Push the plug-in attachment onto the screw knob. Actuate the trigger (C). On the air regulator (D),
the air supply can be infinitely adjusted by turning the knob.
Push the plug-in attachment onto the screw knob. Actuate the trigger (C). On the air regulator (D),
the air supply can be variably regulated by turning the knob.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 25
Advertisement
