Operation - Klarstein Kraftpaket Instruction Manual

EN
12

OPERATION

General instructions for use
• Remove the equipment from its packaging and inspection or if there is any damage.
• Before use, clean the glass of drink mixes with a damp cloth and soap.
• Install beverage mixer on the counter near an outlet network.
• Prepare the ingredients for mixing into the vessel.
• When ready, turn on the mixer with the switch on / off.
• Select the desired speed.
• Place the glass against the trigger switch located near the top of the shaft. The edge
of glass can rest on the ledge to hold the glass in place during mixing.
• Allow the shaft mix the ingredients. The mixer will turn off when the vessel apart from
the switch activator.
• When you finish using your beverage mixer, turn off and unplug the unit.
Operation
• Fill the cup with proper amount of liquid so it does not over flow. Turn the mixer on
and allow the mixing wand to stir the beverage. Choose the appropriate speed
setting (HI or LOW) to mix the liquid.
• Please do not insert your fingers, hand, spatula or spoon into the stainless steel cup
while the mixer is turned on. Keep hands and Fingers clear from mixing wand and
mixing blade while power is turned on.
• When tilting the motor housing for cleaning, please do not allow fingers to become
"Pinched" with the hinge on back brace.
• Please turn the main power switch to the off position and disconnect the power
cable from the power supply before cleaning, servicing, replacing the mixing
blade. Keep power cord away from liquids.
• Please do not run the motor excessively for more than three minutes at a time.