Table of Contents
Advertisement
C
Hole in the
front axle linkage
Turn the vehicle body on its side. Remove the M5x22 machine screw (H) and Ø5
nut (G) from the R/C driver (i) with a screwdriver
1. Attach the R/C driver (i) to the steering gear box, and make it match with the
steering gear box.
2. Insert the straight end of the steering column (19) up through the hole in the
steering gear box from the bottom side, and out through the hole in the dash
through the top.
3. Line up the holes in the R/C driver (i) and find the hole in the steering column
(19), tighten a M5x22 machine screw (H) and Ø5 nut (G) back in the same
location with a screwdriver.
4. Insert the bent end of steering column (19) through the hole in the front axle
linkage.
5. fit a Ø10 washer (D) to the bent end of the steering column (19).
6. Insert a split pin (C) into the hole in the steering column, bend the ends of the
split pin (C) back using long nose pliers (not included).
Attach the Steering Column
D
19
Steering Gear Box
14
Front Bottom View
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
H
i
G
Hide quick links:
Advertisement
Table of Contents
