Advertisement
Charging the Unit
Approximately 3 hours required for full charge.
Unit can be charged by plugging it into a wall socket.
Note: Battery will last for approximately 4 hours when connected wirelessly and
up to 12 hours when connected through Aux-In Audio Jack.
Listening to your device wirelessly over Bluetooth®
To listen to your music over Bluetooth wireless connection, you need to pair your
device with The Sharper Image Freedom:
1. Make sure your device has Bluetooth capability.
2. Slide the POWER switch to turn on the unit, indicator will begin to flash.
3. Follow the instructions of your device to pair the unit.
4. Pair your device with the unit by selecting FREEDOM from your Bluetooth
listings on your device or selecting YES. If prompted, enter "0000" as the
passcode.
5. Press play on your device and use controls on the unit to adjust desired volume.
NOTE: Once you have successfully paired your device, you will not need to
repeat the above steps. Please ensure the AUX cable is unplugged, the unit
source is set to Bluetooth and your device has Bluetooth enabled.
Listening to your device through the Line In Audio Jack
1. Connect Aux-in cable to the headphone or line-out jack of an audio device
and plug the other end of the cable into the Line-In Audio Jack on the back
of the unit.
2. Slide the POWER SWITCH to turn on the unit.
3. Press PLAY on the device and use controls on the unit to adjust
desired volume.
FCC Disclaimer:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Advertisement
