Table of Contents
Advertisement
• If the machine is unplugged or power is interrupted all settings described in chapters 2b. and
2c. must be reset.
• If the machine was set to Auto-On and power was interrupted, the machine will not brew
coffee at the programmed time.
3.The Proper Sequence for Making Coffee
Coffee makers produce very hot water. If you follow the sequence as described below you will
avoid possible accidents which might cause severe injuries and burns.
1. Remove carafe from machine and fill carafe with desired amount of water.
NOTE: Water will be absorbed during brewing process. The carafe level markings indicate
where the water should be filled and how much coffee will be produced. (Fig 3)
2. Open water container lid (Fig. 1, A) and pour water into the water tank. Caution: Make sure
the water level does not exceed the MAX setting If you fill too much water into the water
tank the carafe may overflow with hot coffee.
3. Make sure the filter holder (Fig. 1, D) sits firmly in the filter holder housing. Push the filter
holder down (Fig.4) to make sure the filter holder sits firmly in the filter holder housing. If
the filter holder is not snapped into the housing, the drip stop in the filter holder might not
open during brewing. Hot water and grinds could overflow and leak from the machine.
Caution: When you push against the drip stop from the bottom, and the filter holder lifts
up, re-insert the filter holder. Otherwise the drip stop will not open during brewing. Hot
water could overflow from the filter causing injuries.
4. Insert filter paper (chapter 4b) or a Gold Tone Filter (chapter 4a).
5. Add the correct amount of ground coffee (chapter 4c).
6. Close the water container lid.
7. Make sure the lid sits properly on the glass carafe. Insert the carafe into the machine. The
inner part of the lid pushes the drip stop up, to let coffee brew through.
8. Turn the machine on (Fig. 2, I).
9. Never open the water container lid as long as coffee is brewing. Hot water could spill out
causing burns. Wait until the brewing noise stops.
10. Immediately after brewing is finished there could still be hot water in the filter holder
passing through the ground coffee. This can take 1 to 3 minutes depending on how much
coffee you used and how fine the coffee was ground.
4.MakingCoffee
Please follow the steps described in chapter3.
4a. Using the GoldTone Filter
A size 4 Gold Tone filter comes with the machine. It sits in the Filter Holder. Attention: Coffee
flows slower through a GoldTone Filter than through paper filters. Please see the chart in
chapter 4c for maximum coffee amounts.
4b. Using Filter Paper
8
Advertisement
Table of Contents
