Equipment; Preparing The Coffee Maker; Before First Use; To Set An Auto-On Time - OEM DM1210 Instruction Manual

Fig.4

1. Equipment

The JEP DM1210 comes complete with: Glass Carafe with Lid • GoldTone Filter (inserted
in removable Filter Holder) • Instruction Book

2. Preparing the Coffee Maker

2a. Before First Use
After unpacking your coffee maker clean all the loose parts with warm water and make
yourself familiar with the different functions. After reading these instructions, clean the
internal parts of the machine by making two carafes using only water, without any ground
coffee inside the filter.
2b. The Display / Setting the Clock and Timer
When you plug in the coffee maker the unit will the display (Fig. 2, H.) will illuminate and
show "12:00 ".
2c. To Set the Current Time (Fig.2)
Push and hold the hour button. The hours will advance. The left side of the display will show
AM and PM. When the correct hour shows up release the button and push and hold the minute
button to set the minutes.
Attention: You must change the clock when the time changes (Standard Time, Daylight
Savings Time).
2d. To Set an Auto-On Time:
If you want the coffee maker to start brewing at a preset time automatically, first push the
program button (Fig. 2, M). The display shows "6:00 AM". Immediately start pushing the hour
and minute buttons as described above until the desired time shows up. Within a few seconds
the display will revert to the actual time. To check the programmed time just push the program
button. The display shows the programmed time and will switch back to the actual time. To
change the programmed time, push the program button and repeat as described above.
Attention: Flashing Display!
Fig.5
7