Club Car Turf 2005 Series Owner's Manual page 22

When the switch is in the TOW position, power to the vehicle electrical components is turned off and the vehi-
cle will not operate. See following NOTE.
NOTE: After placing the Tow/Run switch in the TOW position, allow 10 seconds to elapse before switching
back to the RUN position.
After placing the Tow/Run switch in RUN position, allow 10 seconds to elapse before operating the
vehicle.
Figure 11 Tow/Run Switch
The Tow/Run switch should be placed in the TOW position under the following conditions:
• Before Towing the Vehicle: Place the Tow/Run switch in the TOW position to disable all motor braking
functions, thus preventing possible damage that could occur to the vehicle or electrical components if
the vehicle is towed while the Zero-Speed Detect motor braking function is operating.
• Before Disconnecting or Connecting Battery Cables: Place the Tow/Run switch in the TOW posi-
tion to turn off power to the vehicle electrical system, thus preventing severe arcing and possible bat-
tery explosion as the battery cables are disconnected.
• For Long Term Storage: Place the Tow/Run switch in the TOW position to turn off power to the vehicle
electrical system, thus preventing vehicle electrical components from discharging the batteries.
CIRCUIT BREAKER
IQ Plus Vehicles Only
IQ Plus vehicles are equipped with a circuit breaker, located next to the Tow/Run switch. If vehicle speed
slows to one-half of its top programmed speed and a series of rapid beeps is heard, the circuit has been
tripped. Bring vehicle to a complete stop, remove seat, and push breaker to reset. If circuit breaker is tripped
again when vehicle operation is resumed, contact a local Club Car distributor/dealer.
2005 Turf Vehicle Owner's Manual
Controls and Indicators
Page 13