Assembly Method; Base - KMART Hollywood Mirror Manual

4

Assembly Method

4.1 Base

Please Note: a small amount of assembly is required and a Phillips Head
screwdriver will be required.
• Position the two side posts over the holes in the base and then from
underneath, insert the Short screws and tighten with the screwdriver.
• Centre the Mirror over the slot in the base, as shown below, and then
lower down. Push down firm until the mirror rests in the slot.
• Insert the four Long screws into the back of the mirror as shown below
and tighten.
Short
Screws
Page 7 of 12
Long
Screws