Information On Display Panel; Temperature Problem - Bosch KIS Series User Manual

en Troubleshooting
Errors
The base of the refrigerator
compartment is wet.

Information on display panel

Errors
Message showing "D" or "E"
appears in the display.
The temperature display
(freezer compartment)
flashes.
The temperature display
(freezer compartment)
flashes, a warning signal
sounds and lights up.

Temperature problem

Errors
The temperature differs
greatly from the setting.
30
Cause
The condensation channel
or drainage hole are
blocked.
Cause
The electronics have detec-
ted a fault.
The temperature in the
freezer compartment was
too warm.
Different causes are pos-
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Cause
Different causes are pos-
sible.
Troubleshooting
Clean the condensation channel
▶
and the drainage hole. → Page 27
Troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 32
Press .
1.
a The temperature display (freezer
compartment) briefly indicates the
warmest temperature reached in
the freezer compartment. The tem-
perature display (freezer compart-
ment) then indicates the set tem-
perature again.
Press .
2.
a The temperature display (freezer
compartment) no longer flashes.
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 23
Troubleshooting
Switch off the appliance.
1.
→ Page 19
Switch the appliance back on after
2.
five minutes. → Page 19
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.