Product Specifications; Product Set-Up - RaceAmerica 6632E Owner's Manual

PRODUCT SPECS Model 6632E
Display Type:
Digit Size:
Number of digits:
Dimensions:
Mounting:
Housing:
View Filter:
View Range:
Power Reqt:
Weight:
Display Formats:

PRODUCT SET-UP

Model 6632E Large Display Timer is
designed to be mounted into or hung from a
permanent structure.
RaceAmerica has tried to make use of the
display timer as simple as possible, however, it is
strongly suggested that the system be set up in a
race simulation area without stretching the cables
all out to gain familiarity with basic operation of
the components prior to race day. This can be done
in a driveway or garage. Walking through beams
can simulate vehicles for purposes of familiarizing
one with basic operation.
STEP 1 -
Familiarize yourself with the components
pictured in this manual and how they interconnect.
The Track Sensor Interconnect Cable is configured
for connection between the starting line, the
finish line and the timer. Several connectors may
connect different segments of this cable. The
cable is keyed to match the start line and finish
line track sensors, position identified at the track
sensor end of the cable (Fig.2). The large round
connector connects to the display and the smaller
connectors (RJ11) connect to the Track Sensors
at the start line and the finish line as indicated on
the cable near the RJ11 connector.
The display can be mounted or hung (see
7-Segment
15" x 7.75
Five
64.6"W x 22.3"H x 4"D
Back 3/8-16 PEM nuts
Powder coated aluminum
Red Transparent acrylic
660' in full sun
11.8 to 12.6VDC/2A
38#
ss.fff 99.999
sss.ff 999.99
mm:ss.f 99:59.9
hh:mm 99:59
RaceAmerica Model 6632E Display Timer
figure 3).
STEP 2 -
Identify the emitter/sensor placement at the
start line and finish line. The lane width should be
set between four (4) and fifty (50) feet (for standard
5040 Beam Emitters). Layout the Track Sensor
Interconnect Cables on the track site as illustrated
on the Track Sensors/Cabling Diagram (Fig. 2).
STEP 3 - Connect the Power
Power is supplied to the display and sensors
through the 12VDC power input. Connecting
power to the display will set the display into a
power-up self-test sequence. Turn on the Beam
Emitters.
Model 5040 - Infra-red Beam Emitter
Note On/Off switch and placement for four AA
batteries for each Beam Emitter. Beam Emitters
are interchangeable with one another.
Model 5140 - Infra-red Track Sensor
Note cable connector is located inside and
underneath. Track Sensors are interchangeable
with one another.
Fig. 1 - Track Sensors and Emitters
5