Vapotherm Q50 Instructions For Use Manual page 14

Air Outlet
The air exiting the Q50 compressor is to be used only in conjunction
with the Vapotherm Precision Flow system. The compressor output is
designed to match the performance needs of the Precision Flow up
to 40 L/min and as such has no user adjustable settings or gauges.
Air Exhaust
The air exhaust is located on the bottom of the unit and vents the
warm air used to cool the compressor.
WARNING: Do not block or restrict the air exhaust underneath
the compressor. This could result in failure to
deliver therapy as intended. When the unit is
placed on the floor, be sure that any flooring, such
as carpet, does not restrict the air exhaust.
WARNING: Do not remove the compressor feet. These are
designed to reduce noise and provide the required
space to allow the compressor to circulate sufficient
cooling air throughout the system. Removal of the
feet could result in overheating of the system and
excessive noise.
WARNING: The bottom of the unit may become uncomfortably
warm if air flow is obstructed or under a single
fault condition. Do not lift the unit from the bottom
immediately after use.
Page 12 3100772 Rev E