Ortech LEDFP-3-43 Manual page 5

Fireplaces
MODEL LEDFP-3-43 | LEDFP-3-50 | LEDFP-3-60
WALL MOUNTED INSTALLATION
4. Mark out location, then mount the bracket(s) onto the wall using the supplied screws. This bracket MUST have the hooks
facing upward and be level. It is strongly recommended that the mounting bracket be screwed into the wall studs
where possible. If the wall studs cannot be used, ensure that the supplied plastic anchors are used to affix the
bracket to the wall and the bracket is adequately secured.
5. With the wall mounting bracket installed, have two people lift the appliance up and insert the two hooks on the bracket into
the two slots on the back of the appliance
6. Check the appliance for stability ensuring that the bracket will not pull free from the wall
5. After the installation, your Electric fireplace will look like
Diagram A shown below
Diagram A
LOG-SET / CRYSTAL EMBER INSTALLATION
*PLEASE MAKE THE INSTALLATION ACCORDING TO THE EMBERS WHICH YOU BOUGHT OR SELECTED.
1. Glass front must be removed and the appliance must be mounted in its final location before the log-set / crystal / embers
are installed
2. If your fireplace come with log-set, take the log-set out of the package and put it to the fireplace media slot (see fig.1)
3. To switch to Crystals, firstly take the Log-set out of the fireplace slot, then place the plastic tray to the fireplace designed
place. Then carefully place crystal embers into the plastic tray as illustrated below. (see fig.2 and fig.3)
4. Apply an even layer from side to side. (see fig.2 and fig.3)
Fig.1
info@ortechindustries.com
www.ortechindustries.com
Fig.2
13376 Comber Way 375 Admiral Blvd
Mississauga
Surrey BC V3W 5V9
LEDFP-3-43 | LEDFP-3-60
Wall Bracket Illustration
Fig.3
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474