Advertisement
HANDHELD MICROPHONE
1. Grille (capsule inside)
2. Power/low battery Indicator
3. Power ON/OFF/MUTE Switch
4. Battery Compartment/Cover
Operation
1. Open battery cover. Install the provided 2pcs 1.5V AA batteries and then
close the cover. Pay attention to the correct polarity.
2. Slide power switch to "ON" position to turn on the microphone. Power indicator
will ash once and then go o . This indicates correct operation.
3. Now receiver RF indicator should light. Please con rm frequency of
microphone same as the receiver before operation.
4. Slide power switch to center "MUTE" position to mute the sound.
5. During operation if power indicator lights red, this indicates the battery is Iow.
Please replace new battery.
6. If the microphone is not going to be used for any length of time, please slide
power switch to OFF position and remove the battery.
RECEIVER
Front Panel
3
4
1
2
8
Rear Panel
14
15
16
17
4
www.PyleUSA.com
1
2 3
5
6
7
9
10
11
12
18
19
20
1. Main Power: Press to switch the unit power to ON and OFF.
2. ECHO: Rotate the echo knob to your desired level.
3. RF 1: The indicator will light red when wireless microphone 1 is on.
4. AF 1: The indicator will light green when speak to wireless microphone 1.
4
5. BT: When main power is ON, the indicator will ash blue fast to be ready to
connect BT audio device. After BT audio device is connected the indicator will
light constant blue. When audio device is playing the indicator will ash blue
slowly.
6. RF 2: The indicator will light red when wireless microphone 2 is on.
7. AF 2: The indicator will light green when speak to wireless microphone 2.
8. W/MIC 1: Rotate to adjust the volume of the wireless microphone 1 and wired
dynamic MIC 1.
9. W/MIC 2: Rotate to adjust the volume of the wireless microphone 2 and wired
dynamic MIC 2.
10. TONE: This control is used to adjust the bass, treble quality of the microphone
sound. The bass is decreased and treble is increased when the control turned
clockwise. The bass is increased and treble is decreased when the control
turned counter clockwise.
11. MUSIC: Rotate to adjust the volume of music.
12. MIC IN 1: Insert the 6.3mm plug of wired dynamic MIC into MIC 1 Jack.
13. MIC IN 2: Insert another 6.3mm plug of wired dynamic MIC into MIC 2 Jack.
14. ANT. B: Receiving antenna of the wireless microphone 2.
15. Video input jack (RCA type): Connect this RCA Jack to DVD, Streamer,
Set-Top Box or any other A/V source for video in.
16. Audio input jack (RCA type): Connect this set of RCA Jack to DVD, Streamer,
13
Set-Top Box or any other A/V or Audio source for audio in.
17. Video output jack (RCA type): Connect this RCA Jack to TV or Screens for
video out.
18. Audio output jack (RCA type): Connect this set of RCA Jack to Active
Speakers, Hi Fi system for audio out(mixed music and MIC signal).
19. AF OUT (6.35): Alternatively connect this jack to MIC IN of your amplier for
audio out (mixed music and MIC signal).
20. DC IN: Connect DC jack of supplied AC / DC adapter to this jack.
21
21. ANT. A: Receiving antenna of the wireless microphone 1.
5
www.PyleUSA.com
Advertisement
