Page 2
100 Series Intercom Stations back about 1/2 inch. Ensure that the shield is not exposed or it may short out exposed contacts on the intercom PCB when it is installed. The pin configuration of the station connector is: MTA Pin Signal audio + audio -...
Page 3
100 Series Intercom Stations The ICB-100 is designed for mounting to a loudspeaker unit that incorporates a 1/4” thick security baffle such as a Lowell SQLK-8. To install the ICB-100, first the microphone shock mount must be mounted on the rear of the baffle plate as in the following illustration.
Page 4
100 Series Intercom Stations Talkback Kit Microphone Installed The circuit board of the talkback kit is encased in a non-conductive heat shrunk case with two strips of Velcro mounted on the back. Remove the exposed adhesive protective strip from the Velcro and gently press the talkback kit on to a convenient mounting location on the loudspeaker cone frame as in the following illustration.
Page 5
100 Series Intercom Stations Wire Signal Orange Mic - White Mic + Black Speaker Green Speaker Yellow Switch 1 Yellow Switch 1 Switch 2 Switch 2 The intercom talkback unit is connected to a station audio board the same as any other intercom station via the MTA connector.