Cleaning & Maintenance; Troubleshooting - Princess 01.353120.01.001 Instruction Manual

• Clean the filter using a vacuum cleaner to gently absorb dust on
the filter screen surface.
• Use some warm water and a mild detergent if it is very dirty.
Make sure the filter is completely dry before you put it back.
• Push the two hooks to put the filter back into the unit.
CLEANING MAINTENANCE
• Before cleaning, be sure to disconnect the unit from any electric
supply outlet.
• First clean the surface with a neutral detergent and wet cloth, and
then wipe it with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
STORAGE
• Empty the water in the tank.
• Roll up the power cord.
• Clean the filter.
• Store the unit in a cool and dry place.

TROUBLESHOOTING

Problem Possible causes
The machine Is the power line properly
doesn't work. connected?
Full water indicator light is
on (water tank full or not in
the right place).
The room temperature is
above 35 degrees or under
5 degrees.
Is the lock on?
Dehumidification Is the filter blocked?
function cannot
start.
Is the air inlet or outlet
blocked?
The machine Is the machine tilted?
makes noise.
Is the filter blocked?
E1 Code Coil sensor short circuit or
open circuit
Instruction manual
Suggested solution
EN
Connect the plug into the
socket.
Drain the water in the tank and
put it in place.
The protection is started and
the machine will not work.
If the lock is on, please unlock
by press and hold the lock
button for 5 seconds.
Clean the filter (screen)
according to the cleaning
instructions.
Remove the obstruction from
the air inlet or outlet.
Move the machine to a flat,
horizontal surface.
Clean the filter (screen)
according to the cleaning
instructions.
Check if the line is loose or
replace the coil sensor.
11