Unique features of the HELIX DSP.3
96 kHz sampling rate
The HELIX DSP.3 allows to handle all signals with
the doubled sampling rate of 96 kHz. Thus the au-
sponse to more than 40 kHz. Doubling the sampling
Only the implementation of the latest DSP chip gen-
eration allows raising the sampling rate to 96 kHz
and adding new features at the same time.
ACO – Advanced 32 Bit CoProcessor
powerful 32 Bit CoProcessor of the latest gener-
ation for all monitoring and communication tasks,
way higher speeds with respect to setup switching
and data communication with our DSP PC-Tool
allows software upgrades of all components of the
DSP in order to adjust the microcontroller-controlled
changes in the diagnostic system of factory radios
ups instead of the common two.
Smart highlevel input ADEP.3
Modern, factory-installed car radios incorporate so-
phisticated possibilities of diagnosing the connect-
ed speakers. In particular the latest generation of
car radios are equipped with additional monitoring
functions so that failure messages and loss of spe-
if a signal processor will be hooked up – but not with
the DSP.3.
problems without loading the speaker outputs of the
Start-Stop capability
The switched power supply of the HELIX DSP.3
crank.
26
Power Save Mode
-
the HELIX DSP.3 once there's no input signal pres-
ent for more than 60 seconds. Please note that in
ternal bus structures it may happen that the radio
in a second if a music signal is applied. It is possible
DSP PC-Tool software.
Automatic Digital Signal Detection
Switching from analog input to the digital input is
-
done automatically as soon as a signal is detected
on the Optical Input. This feature can be deacti-
you can use an optional remote control for manual
switching between analog and digital inputs.
-
-
-
-
-
-