Advertisement
Quick Links
Instructions Created by an:
Ultimate Suzuki Samurai Tube Doors w/ Arm Saver
Latch System by Low Range Off-Road
(SKU# SEB-TD)
CAUTION:
Safety glasses should be
worn at all times when working with
vehicles and related tools and
equipment.
For additional copies of these
and other instructions go to:
www.lowrangeoffroad
"Instructions"
tab.
Installation Instructions
and click on the
Suggested Tools:
• Standard Screwdriver: Small
• Phillips Screwdriver #2
• Phillips Screwdriver #3
• Impact Drill W/ #2 and #3 Phillips Bits
• Allen Sockets: 4mm & 5mm
• Impact Driver W/#2 and #3 Phillips
Bits (Optional)
• Hammer (if Impact Driver is Used)
Advertisement
Related Manuals for Low Range Off-Road SEB-TD
Summary of Contents for Low Range Off-Road SEB-TD
- Page 1 Instructions Created by an: Ultimate Suzuki Samurai Tube Doors w/ Arm Saver Latch System by Low Range Off-Road (SKU# SEB-TD) Installation Instructions CAUTION: Safety glasses should be worn at all times when working with vehicles and related tools and Suggested Tools: equipment.
- Page 2 Step 1 Step 2 Pop the side view mirror cover open Remove the (3) phillips screws using a using a standard screwdriver. #2 phillips bit in an impact drill. Note: These screws can be hard to remove. If you do not have an impact drill, you could use an impact driver.
- Page 3 Step 5 Step 6 Disconnect the body side of the door Roll the window down 2 or 3 inches so strap by removing the (2) phillips screws you will have a way to hold the door. using a #2 phillips screwdriver. Leave Then close the door.
- Page 4 Step 9 Remove the top (2) phillips screws. Note: If there are spacer washers under Step 10 these hinges keep track of them and While supporting the door with one where they were. It may be necessary hand, open the door with the other and to reinstall them with the new doors.
- Page 5 Step 13 Step 14 Align the holes of the hinge and the door Once all the screws are started, tighten and install both of the supplied bottom all (4) screws using a 5mm allen socket. screws. Leave these screws loose for now.
- Page 6 Step 17 Step 18 The door striker can also be adjusted if Check to see that the door latches and necessary. To adjust, loosen the screws unlatches correctly. Adjust the hinges using an #3 phillips screwdriver, and or striker if needed. reposition the striker as needed, and retighten the screws.
- Page 7 Step 21 Step 22 Start the screw using a 4mm allen Start the other (2) screws. socket. Step 24 Step 23 Snap the cover back into place . . . Once all the screws are started, tighten them all.
- Page 8 Congratulations! You have successfully installed the Tube Doors w/ Arm Saver Latch System by Low Range Off-Road. We hope these instructions have b e e n h e l p f u l . I f y o u h a v e...
- Page 9 Low Range Off-Road Technical Support at 801-805-6644 M-F during regular store hours. Thank you for purchasing from Low Range Off-Road. These instructions are designed as a general installation guide. Installation of many Low Range Off-Road products require specialized skills such as metal fabrication, welding and mechanical trouble shooting.
Need help?
Do you have a question about the SEB-TD and is the answer not in the manual?
Questions and answers