Advertisement
Quick Links
WARNING!
If you do not understand these directions, or if you have any doubts about the safety of the
defective parts. Improper installation may cause damage or serious injury. Do not use this product
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
The Original Ergonomic Single Monitor Arm
INSTRUCTION MANUAL
Product : NeckDoctor for WALL
Color
: Matt Black
Advertisement
Summary of Contents for NeckDoctor For WALL
- Page 1 Improper installation may cause damage or serious injury. Do not use this product INSTRUCTION MANUAL We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use. Product : NeckDoctor for WALL Color : Matt Black...
- Page 2 ASSEMBLY STEPS STEP 1 OPTION A: Wood Wall OPTION B: Concrete Wall Using the wall plate on the arm (A), mark Using the wall plate on the arm (A), mark drilling locations. Drill 2.4” (60mm) deep holes using a recommended. Drill 2.2” (55mm) deep holes 3/8”...
- Page 3 STEP 5 STEP 3 OPTION A: Flat Back Monitor Remove lower nut from VESA plate (B) using the wrench (H) , and loosen the upper two nuts until 3mm Mount VESA plate (B) to TV using bolts (M-A or M-B) with washers (M-F or M-G) , making sure the two of screw thread is exposed for each one.
- Page 4 STEP 7 STEP 9 Use built in cable clips to manage cables. Reinstall lower nut to secure the plate, and tighten all nuts using the wrench. STEP 8 Adjust as Desired Adjust gas spring tension using the 6mm Allen wrench (J) clockwise to decrease.