Ptx_Setup Control - Printronix Auto ID T8204 User Manual

appears early enough on the form so that it will pass completely under the scanning beam during normal
printing. This may involve rotating the form or moving the bar code to a different position on the form.

PTX_SETUP Control

There are several PTX_SETUP commands that configure the ODV-2D symbologies and orientations that
will be processed or ignored, including the ability to skip processing entire labels.
PTX_SETUP commands have the following format:
(SFCC)PTX_SETUP
Command–Sub Command;Value
PTX_END
The SFCC value by default is hex 21 (!) and the entire set of PTX_SETUP commands can be found in the
T8000 Administrator's Manual. Table 5 lists those commands.
Command
GRAPHICS
ORIENT
SKIP
ODV
CODE39
CODE128
INT2/5
CODE93
Table 5 PTX_SETUP Commands for ODV-2D
Sub-Command Parameter
When enabled, search graphics
within the job for barcodes. Other-
ON or 1
wise, ignore the graphics and only
OFF or 0
process the barcode command
from the emulations.
ALL
Choose the orientations of the
PICKET
barcodes to process.
LADDER
Skip a certain number of labels from
ODV2D processing. If zero, no la-
0 = OFF
bels will be skipped (ignored). If
1-9999 = #
1-9999, this number of labels will be
> 9999 = ON skipped. Numbers > 9999 will result
in indefinite skipping of labels.
When enabled, Code 39 barcodes
ON or 1
will be processed. Otherwise, they
OFF or 0
will be ignored on the label.
When enabled, Code 128 barcodes
ON or 1
will be processed. Otherwise, they
OFF or 0
will be ignored on the label.
When enabled, Interleaved 2/5
ON or 1
barcodes will be processed. Other-
OFF or 0
wise, they will be ignored on the
label.
When enabled, Code 93 barcodes
ON or 1
will be processed. Otherwise, they
OFF or 0
will be ignored on the label.
Description
39