Disassembly; Front Cabinet Removal; Mechanism Block Removal; Voltage Selection - Sharp GF-5454H Service Manual

Prior to the disassembly, be sure to remove the AC power
supply cord, cassette tape and batteries from the unit.

• FRONT CABINET REMOVAL

(Refer to Figures 5-1,5-2 and 5-3)
2. Push the stop/eject Button to open the cassette holder.
3. Pull the front cabinet frontward by holding its upper
part and disconnect the speaker socket © .

• MECHANISM BLOCK REMOVAL

(Refer to Figure 5—3)
1. Remove the two screws © and the Digital Tape
Counter Belt ( ).
2. Disconnect the three sockets (f), then the mechanism
block can be removed.
Figure
(Refer to Figure 5—4)
2. Disconnect the two tips (J
3. Remove the six screws <X
can be removed from the back cabinet.
Before operating the unit on mains, check the preset voltage.
If the voltage is different from your local voltage, adjust the
voltage as follows: Slide the AC power supply socket cover
by a little loosing screw to the visible indication of the side
of your local voltage. See Figure 5-5.

DISASSEMBLY

5-2
, then amp. and tuner P.W.B.

VOLTAGE SELECTION

'
о
о
Screw
-5-
Figure 5—1
Figure 5-3
Figure 5—4
о о
Figure 5-5