ExtraHop Discover EH3000 Manual

Install the SSL Decryption Board
Published: 2020-03-21
The following procedures explain how to install the SSL decryption card in an ExtraHop Discover appliance.
The SSL decryption board comes pre-installed in all new rack-mounted Discover appliance hardware.
Shut down the system
Before you open the Discover appliance, shut down the system and disconnect the appliance from the
electrical outlet.
1. Log in to the Administration page on the ExtraHop system through https://<extrahop-hostname-
or-IP-address>/admin.
2. In the Appliance Settings section, click
3. Click Shutdown.
4. On the confirmation page, click
5. Disconnect the Discover appliance from the electrical outlet.
Remove the cover
The cover protects the components inside the Discover appliance and helps maintain internal air flow.
Removing the cover actuates the intrusion switch, which helps maintain system security.
1. Extend the Discover appliance from the data center rack.
2. Rotate the latch release lock counter clockwise to the unlocked position.
3. Lift the latch toward the back of the Discover appliance.
The cover slides back and the tabs on the cover disengage from the slots on the chassis.
4. Hold the cover on both sides, and lift the cover away from the Discover appliance.
Warning: The internal drive installed in your Discover appliance might dislodge when you open
Install the card
The SSL card must be installed in the correct slot to function correctly. The slots are labeled on the rear of the
Discover appliance.
1. Unpack the SSL card.
2. Determine the correct PCI slot for your Discover appliance model:
Discover appliance
EH3000
EDA 3100
EDA 4200
EDA 6100 and EDA 6200
EDA 8100 and EDA 8200
EDA 9100
EDA 9200
Shutdown or
Shut down.
the case. Make sure the drive is properly seated before reinstalling the cover.
Restart.
Slot Number
2
2
2
2
2
1 or 6
8
©
2020 ExtraHop Networks, Inc. All rights reserved.