Hydraulic System; Electric System - Abbriata M100 Series Use And Maintenance Handbook

Use and maintenance handbook – ed_07/04/2016

HYDRAULIC SYSTEM

The connection of the hydraulic net of the round baler with the tractor allows to control the following operations:
1. opening and closing the rear door;
2. raising and lowering the pick-up.
The above is possible through the following devices:
• door opener control hose 3 to be connected with the outlet of lever P of the tractor (insert B fig, 16/A);
• raise pick-up control hose 4 to be connected with the outlet of lever R of the tractor (insert B fig. 16/A);
• deviator / switch attached to hose 19 to be connected, on tractor side, with the outlet of lever S of the tractor (insert D
fig. 16/A);
• deviator / switch 23 to select alternatively, the pick-up or the rear door movement (insert D fig.16/A).
®
ABBRIATA round balers can be connected to the tractor with a set of two hydraulic hoses no. 3 - 4 (insert B fig.16/A) or
with one hydraulic hose 19 and switch 23 (insert D fig. 16/A).
When the tractor is equipped with at least two independent hydraulic levers P and R, connect hydraulic hoses 3 and 4 (insert
B fig.16/A) to the corresponding hydraulic outlets of the tractor. By means of the above mentioned levers, it is possible to
drive directly, without selecting switch, the pick up and the rear door movement (see insert B fig. 16/A).
When the tractor is equipped with only one hydraulic lever S, connect hydraulic hose 19 (insert D fig.16/A) to the
corresponding hydraulic outlet of the tractor. By means of the above mentioned lever, it is possible to drive the pick up or
alternatively the rear door depending on the previously selected position of the lever of switch 23 fig.16/A (see insert D
fig.16/A).
WARNING!
The hydraulic hoses can break. It is therefore important to pay attention to any leakage of hot oil under pressure.
The hoses and the hydraulic components conform to prEN 982.
Maximum working pressure: 330 bar - bursting pressure: 1450 bar.
Hydraulic hoses must be replaced every 5 years from the date printed on them.

ELECTRIC SYSTEM

The green light (G fig. 16/E) signals that the control panel (B fig. 16/C – fig. 16/D and fig.16/E) is powered up.
The horn (K fig. 16/E) acoustically advises that the previously selected pressure of the bale has been reached.
The red light (I fig. 16/E) contemporarily signals, together with the horn above, that the previously selected pressure of the
bale has been reached.
The switch (H fig. 16/E) allows to deactivate and activate the horn.
The deviator (F. fig 16/E) active on the M120/M150 round balers which can be equipped with both Twine and Net binders,
allows to choose whether to use the Twine or Net binding.
The "START" button (C fig. 16/E) commands the start of the Twine or Net binding previously selected.
Connect the tractor's electrical system to the 7 polarity plug (n°.34 fig. 16/C – fig. 16/D) to activate all the lights and gear
motors of the twine and/or net binder.
Try to operate the round baler's electrical system before driving on the road or before starting to bale the product – to set up
tractor socket see pag. 22 / 23.
Fig. 16
Round baler – M100 / M120 / M150
19