Abbriata M100 Series Use And Maintenance Handbook page 16

9. To adjust the pressure of the bale,
position lever E (fig. 8/A , detail B) from 1
(min. density) to 7 (max. density).
For further adjustment of the pressure of the
bale, shorten or lengthen spring no. 4 Fig.
8/A within the limits from 1 to 3 (Fig. 8/A -
detail "C") using rod 10 with its nuts.
ATTENTION!
Very important! Be sure spring 4 is
lengthened at the same level on both left
and right sides.
In general we suggest that you bale (E.G.
dry hay) mainly with lever E (fig.8/A, detail B)
in position 3 or 4 and with spring 4
lengthened to the factory setting position of
1.7 (fig.8/A detail C).
The above is valid for all types of "M100"
and "M120".
For "M150" in general we suggest that you
bale (E.G. dry hay) mainly with lever E (fig.
8/A detail B) in position 3 or 4, spring 4
lengthened to the factory setting position of
1.7 (fig.8/A detail C) and the length T of rod
21 fig. 8/A set to 261 mm as in the factory.
ATTENTION!
• Before starting to work, check that the
rear door is completely closed, be it the
hooking lever (n. 7 Fig. 8/A) is completely
closed. It means it is in contact with its
pivot 8 fig. 8/A.
In the above mentioned conditions the
clearance between the inner part of the
hook no.7 Fig.8/A and the pivot n. 8 must
be about 2 mm. (see fig.8/A detail D).
Please find this clearance adjusting the
position of hook 7 Fig. 8/A by means of
bolt 9 Fig. 8/A.
• When the rear door is opening, make
sure that the minimum distance between
the tip of hook 7 fig.8/A and pivot 8 fig.8/A
is from 16 to 20 mm (see fig.8/A detail D).
Pls find this clearance adjusting the
position of hook 7 fig.8/A by means of bolt
22 fig.8/A.
• Lubricate through greasers n. 5 Fig. 8/A
(right and left) the relevant bushes, once
a working day.
• Adjust
the tension
transmission chains,
special tensioners (fig. 9).
ATTENTION!
The round balers are tested and the
necessary adjustments are made by the
manufacturer. It is important, however, for a
general check, to run the machine on empty
for a few minutes. The machine should be
considered in the break-in period for the first
100 bales, then all the adjustments should
be checked again: above all chain tension
then tightness of screws, lubrication, closure
of hooks, binders, etc.
Round baler – M100 / M120 / M150
16
Use and maintenance handbook – ed_07/04/2016
of the
by using the
Fig. 8/A
Fig. 9 Fig. 10